Furrion Chill Cube A/C for 2013 Forest River Sabre 5th Wheel Bedroom

The 2013 Forest River Sabre model year does not establish which bedroom A/C will fit or how much cooling capacity it needs. The earlier 14,500-BTU ChillCube recommendation, assumed bedroom dimensions and claim that the camper is pre-wired were not verified. Cooling load, roof structure and opening, ceiling clearance, electrical supply and the intended air-distribution arrangement must be checked for this exact camper.

ChillCube is not one universal direct-blow system. Lippert distinguishes ducted and non-ducted models: for example, white 18K non-ducted FACR18VSSA-PS-AM is part 2024039637, while white 18K ducted FACR18VSDA-PS-AM is part 2024039645. A non-ducted configuration distributes air into the room through its matched indoor air box; a ducted configuration uses its approved air box and duct system. Do not choose between them from vent appearance or assume their rooftop units, air boxes and controls interchange.

Lippert also documents a separate 15K low-profile ChillCube heat-pump family. That identifies another capacity/profile category to evaluate, not a confirmed smaller bedroom replacement or current orderable package for this Sabre. Exact part numbers, model suffixes and their matching air-box/control documentation matter; neither the 15K nor 18K designation establishes appropriate cooling load, physical fit or installation difficulty.

At a planning level, the installer must first identify the roof opening/support and existing equipment, select the approved rooftop/air-box/control combination, verify power and any duct or furnace/zone interfaces, and then install, seal and test according to that exact model's instructions. Pre-wiring alone does not make this a straightforward swap. Have a qualified RV A/C installer assess the job rather than relying on generic wiring or mounting steps.

Identification references: 2024039637 non-ducted rooftop listing, 2024039645 ducted rooftop listing, Lippert's model/part compatibility index and 18K component chart. These are not confirmed Sabre fit or a complete installation kit.